need your help guys. i installed a compustar rs (cm5200) and i use the idatalink ads-tb as my bypass. all my keyless wirings are good but i cant remote start the car. i program the bypass and its good. when i try to insert the key at the key barrel and remote start the car and its working. what do you think is the problem? i try to use a different unit and bypass and still cant remote start the car.
do i need to connect the disarm wire (blue) to the rs unit? where can i get that wire other than the power window module?
where can i connect the pink wire (ignition input) of the ads-tb bypass to the vehicle?
where can i find the trunk release wire?
thanks in advance
-------------
tianot
If the car will remote start with the key in the cylinder, the problem has to be with the bypass or it's wiring.
hi! i check my bypass wiring and it looks good but im not sure the pink wire (ignition input) of the ads-tb. where should i connect that wire? in the ignition wire (BLACK / YELLOW) of the accord?
if i dont connect the disarm wire of the rs unit to the disarm wire (blue) , can i still remote start the car?
thanks
-------------
tianot
hi! can i connect together the rearm wire and lock wire of the rs unit and attach it to the lock wire of the vehicle (same as the disarm and unlock)? so that i dont need to open the drivers door module to get the blu disarm wire.
thanks
-------------
tianot
If simply inserting the key into the cylinder lets the car start, the factory arm/disarm does not have anything to do with it.
ok..
this is my ads-tb bypass wiring
GREEN/ red ----- blue wire at the key barrel
gray/red ------ red wire (ecm side)
gray / YELLOW------- red wire(connector side)
pink---------- BLACK / YELLOW ignition wire at tge ignition harness
-------------
tianot