2007 nissan murano 2nd acc and start

I'm installing a compustar Cm6200 remote start in an 07 Nissan Murano and the vehicle asks for a 2nd starter and a second accessory (which is funny because it tests as an ignition).
Starter wire 1 is a BLACK/ red
starter wire 2 is a BLACK / YELLOW
Ignition is BLACK/ red as well
Accessory is red (tests as an ignition)
Accessory 2 is WHITE/ blue (tests as acc)

My question is with one programmable 2nd output from the compustar how can I hook up the 2nd acc and starter. Any help is appreciated.

Make the standard CN1 connections to ACC1, Starter1 and Ignition wires.

The Compustar CM6200 should come with a loose extra relay.  Use that for the BLACK / YELLOW Starter2 wire.  Connect the relays Red witre to +!2v Constant, the Blue wire to the vehicles BLACK / YELLOW Starter2 wire and the Purple wire to the RED / Black wire at CN3-5 ( (-) 250mA Second Starter Output ).

Do basically the same thing for the vehicles WHITE/ Blue Accessory2 wire.  Purchase a 30/40 Amp SPDT relay and wire as follows.
Pin 85 to CM6200 WHITE/ Black wire at CN3-9
Pin 86 and 87 to +12V constant thru 20 Amp fuse
Pin 30 to WHITE/ Blue ACC2 wire
Pin 87A not used - insulate

-------------
Soldering is fun!

Thank you for the reply.. I did want to do that I just thought that the compustar could only handle one extra 2nd acc/ignition/starter through its programming. I have many duplicates of that loose relay compustar comes with. So that is ok to do?

Absolutely.        That is exactly what the extra relay and those CN3 POC outputs are for. 

-------------
Soldering is fun!

Thank you so much for your help everything went perfectly!