aps787c and flashlogic flcan
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=133248
Printed Date: May 19, 2024 at 5:13 AM
Topic: aps787c and flashlogic flcan
Posted By: mbee1
Subject: aps787c and flashlogic flcan
Date Posted: January 09, 2013 at 1:08 PM
hello everyone, how do i know if i download the correct firmware for flashlogic flcan. 2011 dodge ram 1500, aps787c, flcan for remote start. i have 5 choices and narrowed it down to 2 due to tipstart model.
Replies:
Posted By: kreg357
Date Posted: January 09, 2013 at 1:19 PM
Think this is the one you need.
FLC-AL(DL)-CH4 (2.5) FOR FLCAN
-------------
Soldering is fun!
Posted By: mbee1
Date Posted: January 10, 2013 at 1:22 PM
thank you. and wiring diagram would be helpful. anyone?
Posted By: kreg357
Date Posted: January 10, 2013 at 2:15 PM
Posted By: mbee1
Date Posted: January 10, 2013 at 2:49 PM
thank you. im having trouble reading what size diode on type 2 wiring diagram. from 1st ignition input (+) after that fuse? any suggestion?
Posted By: kreg357
Date Posted: January 10, 2013 at 3:03 PM
It is listed as a 1N4001, but any commonly available ( 1N4004 or 1N4007) diode will work fine.
-------------
Soldering is fun!
Posted By: mbee1
Date Posted: January 11, 2013 at 9:15 AM
wow, this is so confusing. hardest remote start w/ security yet. everything on the audiovox tech services diagram says, do not use for remote start. i was thinking easy after that honda i did. says i need just five wires from the vech but everything for the alarm side says i cannot use for remote start. lost...
Posted By: mbee1
Date Posted: January 11, 2013 at 9:39 AM
ok im taking my time and soldering everything using the hard wire type 2 diagram. does anybody have any tips or shortcuts to help me out here. ty
Posted By: kreg357
Date Posted: January 11, 2013 at 9:43 AM
It is confusing but all in all, it makes the remote start install very easy. Here is a link to a
similar install : https://www.the12volt.com/installbay/forum_posts.asp~TID~130163~PN~1
The major differences will be your brand of remote start system and the vehicle wire
color and locations. The Pictorial was done in W2W mode whereas yours will be in
D2D mode. Not many wires to connect, it is all done thru the CAN bus. ------------- Soldering is fun!
Posted By: mbee1
Date Posted: January 11, 2013 at 9:51 AM
very nice. the picture of the R/S and module is very clean. very clean set up I like the way you do things. and thanks for your help
|