2008 lexus is250 bypass pressing brake

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=133506
Printed Date: May 18, 2024 at 6:22 PM

Topic: 2008 lexus is250 bypass pressing brake

Posted By: xbimmer
Subject: 2008 lexus is250 bypass pressing brake
Date Posted: February 03, 2013 at 9:18 AM

hi how do you bypass putting your foot on the brake ,when remote starting ?
thank you

Replies:

Posted By: dasbogie
Date Posted: February 03, 2013 at 10:25 AM

Are you asking a general question or are you installing a remote starter? If you are installing equipment, listing what pieces and parts you are using will help answer questions . Most pts. Installations have you connect the start wire from the remote starter to the foot brake.

-------------
Advanced

Posted By: soundnsecurity
Date Posted: February 03, 2013 at 10:27 AM

are you asking how to simulate pressing the brake during remote start for a push button starter? what remote starter and what bypass are you using?

-------------

Posted By: howie ll
Date Posted: February 03, 2013 at 1:00 PM

Why do I have a feeling this is going to run to quite a few pages? posted_image

To the first poster if you have to ask that question, you shouldn't even be attempting this installation.
It isn't just powering up the switched side of the brake switch, you'll need an immobiliser by-pass as well.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Print Page | Close Window