viper 5704 h3/8 wire
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=133672
Printed Date: May 15, 2024 at 9:28 PM
Topic: viper 5704 h3/8 wire
Posted By: mavrick5522
Subject: viper 5704 h3/8 wire
Date Posted: February 23, 2013 at 8:43 PM
Hi all this is my first post so if I didn't post in the right place or did something wrong I'm sorry.
I just finished installing a viper 5704 in a 2003 escalade and got a lot of the info I needed from this forum but could never figure out what the h3/8 pink/black (87a) FLEX RELAY INPUT (key side of ign, acc or starter wire if needed)was for. all the info I could get was it wasn't needed. Could someone explain what it is actually used for. I would like to know for future install. Thanks
Replies:
Posted By: howie ll
Date Posted: February 24, 2013 at 1:08 AM
Some vehicles will feed back through a second ignition wire because ignitions 1 and 2 are connected at the switch. When the alarm is on, this will cause the alarm to go off when you activate the R/S.
Garbage Peugeot and Citroen in Europe and I believe some Toyotas so you wire the second ignition after cutting as key side to pink/black and ignition side to pink/white similarly to the violet and green at H3/4 and H3/5.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: mavrick5522
Date Posted: February 24, 2013 at 2:18 PM
Wow that sounds simple enough. Thanks for the reply howie.
|