Varad Gothic LED Scanner HookUp

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=13476
Printed Date: June 10, 2024 at 4:39 PM

Topic: Varad Gothic LED Scanner HookUp

Posted By: VicVicious
Subject: Varad Gothic LED Scanner HookUp
Date Posted: May 13, 2003 at 10:25 AM

Still new to installations so before I break something let me holla at you all. Im wiring this new scanner into my system and its a 3 wire hook up. I plan to just snip the current LED status light wires and solder in the new ones directly. Give it a ground and keep it moving. This sound about right? Or will I need to do more?
Thanks N Advance

Replies:

Posted By: cpgoose
Date Posted: May 14, 2003 at 9:19 AM

You might want to wait for someone else to concur with this....but I think you can do the following:

1. Snip off the current LED, leaving you with the red and black wire from that.
2. Hook up the red wire from your scanner led to the red wire from the old led.....do the same with the black wires.
3. Hook up the yellow wire from your scanner to the "ground when armed" wire of your alarm...so the scanner knows when to turn on.

By the way, I looked here for help on this....the FAQs, and the manual.

Print Page | Close Window