Print Page | Close Window

flashlogic and starter

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135353
Printed Date: May 28, 2024 at 4:06 PM


Topic: flashlogic and starter

Posted By: oldsmobile94
Subject: flashlogic and starter
Date Posted: November 23, 2013 at 6:42 AM

hey not sure what wires or wires to hook up to my flashlogic bypass from my hornet 564t alarm and starter. the flashlogic unit says hook up the starter wire to it but the alarm an start unit has 2 a keyside and a motorside not sure which 1 to connect or should I connect them both?

-------------
TK



Replies:

Posted By: kreg357
Date Posted: November 23, 2013 at 6:48 AM

Could use some more info.  What Year, Make and Model of vehicle?  What firmware is flashed on to the FLCAN? 

Typically, if the bypass needs to see a (+) Starter input, you would use the "motor" side ( Purple wire ) from the R/S.



-------------
Soldering is fun!



Posted By: oldsmobile94
Date Posted: November 23, 2013 at 9:02 PM
the vehicle is a 2009 jeep liberty, the firmware on the bypass is FLC-AD(DL)-ch5. guide # 10762.

-------------
TK


Print Page | Close Window