avital d2d activate

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135671
Printed Date: June 01, 2024 at 12:24 AM

Topic: avital d2d activate

Posted By: jnz1
Subject: avital d2d activate
Date Posted: December 31, 2013 at 2:06 AM

To activate the d2d is it just connecting the white and blue to ground and turning the ignition on and off? I have everything hooked up, but didn't know it did not come in d2d mode.

Replies:

Posted By: Chris Luongo
Date Posted: December 31, 2013 at 6:40 AM

Not ignition, but constant power to the module.

1: Remove power by either unplugging the connector with the constant feed, or pull the fuse on that wire.

2: Connect WHITE/ blue to ground.

3: Reconnect constant power.

4: Observe the Avital LED; it tells you whether you're in Bitwriter or data mode. The instructions tell you what the LED is supposed to be doing. Or just skip this part if you don't have the instructions.

5: Remove the ground from the WHITE/ blue.

Posted By: jnz1
Date Posted: January 04, 2014 at 9:04 PM

Thanks again, although in the end I choose to w2w.

Print Page | Close Window