xk06 03 chevy malibu
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136191
Printed Date: June 05, 2024 at 6:06 AM
Topic: xk06 03 chevy malibu
Posted By: jnz1
Subject: xk06 03 chevy malibu
Date Posted: March 01, 2014 at 12:28 AM
I am having an issue getting the xk06 to learn the resistance code on a 2003 Chevy Malibu. The firmware is plxr v3.0. I used installation d which seems pretty direct no cutting wires just splicing in. I get the bypass to program to passlock two and the try the starting the car to program code, but led stays on solid and when the button is held it goes out, no clicks, nothing learned and light comes back on solid.
Replies:
Posted By: co_ne_dub
Date Posted: March 01, 2014 at 9:03 AM
How are you wired? Is your brown wire from the xk06 connected when you tried this? That wire only gets connected AFTER you have programmed the bypass to the vehicle.
Posted By: jnz1
Date Posted: March 01, 2014 at 12:33 PM
Wiring is as follows
Brown - not connected
Green - not used
Blue - To yellow passlock wire
Violet/White - not used
Violet - not used
Pink/White - not used
Pink - to pink ignition wire
Orange - to yellow starter wire
Red - to 12v red ignition wire
Black - to Black passlock wire
Posted By: jnz1
Date Posted: March 02, 2014 at 9:12 PM
Checked the wires all were soldered up, wanted to finish up. Pulled the xk06 and went with a relay and resistor. Worked like a charm.
|