viper 5704 dodge factory keyless
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136285
Printed Date: May 28, 2024 at 2:08 PM
Topic: viper 5704 dodge factory keyless
Posted By: s_clm8
Subject: viper 5704 dodge factory keyless
Date Posted: March 16, 2014 at 6:18 PM
I have a 2001 Dodge Ram with factory keyless entry that I installed a Viper 5704 in. I have everyhting working but the door locks. I have the DEI 451m module which is required since it is a 5 wire system. I am just unsure which wires I need to tap into. I just don't want to cut some wires and not being sure which ones they are.
Replies:
Posted By: harryharris
Date Posted: March 16, 2014 at 6:37 PM
Apparently on KE models the lock wire is 12V+ and the unlock is 5 wire.
If so (test first) do the following.
451 violet and violet black to a good 12V+ constant.
451 WHITE/ black not used.
451 GREEN/ black to ORANGE / purple driver kick panel.
Pink purple, driver kick panel; cut it and carefully strip the ends.
The side that shows 12V+ on unlocking, connect to the 451 BROWN / black.
The other side connect to the 451 blue/black.
-------------
Test before boxing up.
Posted By: s_clm8
Date Posted: March 17, 2014 at 8:15 AM
is it the wire harness with the locking clip below the one that goes thru the firewall? I was messing with the 451M the other day and I found out two wires that you stated work when you ground the two you don't use. So I cut the pink/purple wire in half and put a wire from the module to both sides?
Posted By: harryharris
Date Posted: March 17, 2014 at 4:12 PM
No idea, you're on your own with that one, you have to test first.
-------------
Test before boxing up.
|