viper 5706v remote issues
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136412
Printed Date: May 03, 2024 at 6:32 AM
Topic: viper 5706v remote issues
Posted By: reesycup
Subject: viper 5706v remote issues
Date Posted: April 07, 2014 at 8:34 PM
So I saw the new Viper 5706v online and had to have one. Being an installer for 10 years I thought this upgrade would be easy. After I had completed the install on my truck everything works. However the remote will send the command, the alarm will complete the command, but instead of confirming the command the remote beeps and icon flashes like it is out of range. I have deleted and re-paired the remote but it still does the same stuff. I called DEI but since my shop is no longer a Viper dealer they will not help. Guidance please......
Replies:
Posted By: smokeman1
Date Posted: April 07, 2014 at 9:09 PM
Try disconnecting the power to the 5706 brain for 10 minuets or so. Pull the fuse on the red 12 volt of the 6 pin harness. See if that clears up the issue.
-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation
Posted By: harryharris
Date Posted: April 07, 2014 at 11:44 PM
Not sure if you're upgrading from an 04 series but if that's the case, please note:-
Different antenna AND antenna lead, change both.
Tell me about it, luckily I bench tested my first a while back.
Otherwise follow Smokeman's advice.
-------------
Test before boxing up.
Posted By: reesycup
Date Posted: April 08, 2014 at 6:30 PM
I changed everything as I was going from an avital system to this viper.
|