fortin evo all programming problems
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136785
Printed Date: June 05, 2024 at 4:31 AM
Topic: fortin evo all programming problems
Posted By: monti755
Subject: fortin evo all programming problems
Date Posted: June 11, 2014 at 9:20 AM
2012 TOYOTA Corolla G-key and Fortin EVO-ALL:
Connections:
Ignition-1: Connected to A1 Fortin EVO-ALL
CAN LOW: Pin 14 OBD2 Diagnostic Port connected to C4 Fortin EVO-ALL
CAN HIGH: PIN 6 OBD2 Diagnostic Port Connected to C3 Fortin EVO-ALL
Immobilizer Data: Pin 7 OBD2 Diagnostic Port Connected to A10 Fortin EVO-ALL.
All other connection go trough D2D.
Problem:
Installation Produre 5: The red light never flashes 10x times after turning the Ignition to ON/RUN Position. Waited 1 hour and the red light never flashed 10x Times neither the Blue light. Tried few times.
Fortin EVO-ALL was Flashed with the firmware of the car model and year. The firmware versión suggested from Flashlink Updater Software is 79.12 Hardware versión 6.
Anybody has a clue on how to solve this problema and what could be wrong. Thank you very much for any help in Advance.
Replies:
Posted By: Chris Luongo
Date Posted: June 11, 2014 at 9:24 AM
I'm not sure, but Fortin does have a troubleshooting guide online. It's a great tool, but they need to publicize it more.
Go to ifar.ca
Type in the kind of car it is, and you'll see the product and installation guides show up.
Now, look at the tabs, and there's one you can click on the says "Troubleshooting."
From there, you click on which color LED is flashing, and so forth.
|