2014 prius c r start hybrid error

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137183
Printed Date: April 28, 2024 at 12:37 AM

Topic: 2014 prius c r start hybrid error

Posted By: kenca
Subject: 2014 prius c r start hybrid error
Date Posted: August 31, 2014 at 8:59 PM

I installed a few diy remote starter with fortin evo all with success. This is my first time installing with idatalink blade al bypass module with firstech FT-6200S. I connected all the wires shown on type 10 for prius c 80 bit keys from https://www.idatalink.com/product/product/product_id/4 blade al tl5 installation guide and the blade seems to work properly based on the above guide. When I remote start the car it started and got the "ready" light but I get hybrid error. I bought the cable to reflash the blade module but same problem.

Replies:

Posted By: tonanzith
Date Posted: August 31, 2014 at 9:19 PM

Does it light up also during regular start or only on remote start?

-------------
Gary Sather

Posted By: kenca
Date Posted: September 01, 2014 at 9:37 AM

only on remote start.

Posted By: catback
Date Posted: September 01, 2014 at 11:56 AM

You have all (except keysense) the ignition connector wires hooked up (12V, Ign A, Ign B, Acc, Starter)?

Where are you taking power for the FT-6200S from? I wouldn't use the 12V wire at the ignition connector for anything other than powering the remote start harness that feeds the ignition connector.

Posted By: kenca
Date Posted: September 01, 2014 at 9:44 PM

yes 12v, ground, ign, acc, starter, -parking. On the blade I connected the canH, canL, Immobilizer data, ground, doorlock data, and -ground input hook up to ground when running on the FT-6200S. No I didn't connect keysense, the guide said not to connect it. I used the 2 back 12v wires from the ignition to power the two red 12v on the FT-6200S.

Posted By: catback
Date Posted: September 02, 2014 at 10:09 AM

There are two ignition wires A and B, they both have to be connected. Also recommended place to grab 12v is at the fuse box, the idatalink guide says the given black 12v wire at the ignition connector only supports 7.5 amps.

Posted By: kenca
Date Posted: September 02, 2014 at 8:49 PM

Problem solved thank you. I didn't connect ignition B.