avital 5303l
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137228
Printed Date: May 01, 2024 at 9:32 AM
Topic: avital 5303l
Posted By: dawgsmansc
Subject: avital 5303l
Date Posted: September 09, 2014 at 10:36 AM
Ok so I've had my Avital 5303L+PKALL bypass installed in my 2007 Toyota Tundra X-SP for about a year now. I recently let the battery in my two-way remote die for an extended period of time (maybe about 16 hours). Now my two-way remote won't talk to the system. The one-way remote works just fine and when I operate the various functions (lock/unlock/remote start) it will communicate it back to the two way, but the two way will still not talk to the system. Steps I've take so far: press the unlock button on the two way over and over to "re-sync" the system; put the key in the ignition and in the on position and within 10 seconds press and hold the valet button and press the unlock button; I have ensured that the remote valet switch is in the "operate" position. I'm racking by brain here. Any help would be greatly appreciated, thanks.
Replies:
Posted By: howie ll
Date Posted: September 09, 2014 at 10:38 AM
Try to pair the two way with the system.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: dawgsmansc
Date Posted: September 09, 2014 at 10:53 AM
would you mind elaborating a little more, i don't see anything about pairing in the install guide nor owners manual
Posted By: howie ll
Date Posted: September 09, 2014 at 11:12 AM
Go to the official website, download installation guide from the support part pp34-35.
Quick and dirty assuming door trigger is connected, open door turn on ignition.
Within 5 seconds push and hold valet switch
You should get an extended beep from siren.
Release switch then push and hold again, press padlock button on remote, again should get a beep.
Job done.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: catback
Date Posted: September 09, 2014 at 11:21 AM
Pressing unlock does not help to resync, you press lock to resync. The same deal when you are learning the transmitter, you must press lock not unlock.
Posted By: dawgsmansc
Date Posted: September 09, 2014 at 5:45 PM
catback - that was a typo, I was tired.
howie II - thanks a ton, i ended up having to reprogram both remotes because i somehow screwed up the one way too, but it's all good to go as of now. Not sure how i didn't look in that section, especially when it specifically says what i need to do. Again thanks so much.
|