remote starter runtime issue
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137440
Printed Date: May 02, 2024 at 3:50 AM
Topic: remote starter runtime issue
Posted By: johnnygaloshes
Subject: remote starter runtime issue
Date Posted: October 13, 2014 at 7:40 PM
I have an Autostart AS-1775 that has a peculiar problem. I have it set to run the max 25 minutes runtime. The vehicle all works fine, (doors, lights, hood switch) except when it starts via remote, it runs for EXACTLY 2:30, then shuts off, then restarts and then runs for EXACTLY 2:30 again then shuts off then restarts, and once again runs for (You guessed it!) 2:30. It also does this if i reset the module back to factory. It doesn't have another remote nor is anyone touching the vehicle or remote. I am leaning towards the tach wire not seeing the correct reading but then again why is it running exactly 2 minutes and 30 seconds.
Suggestions?
Thanks!
Replies:
Posted By: sparkie
Date Posted: October 14, 2014 at 4:38 PM
List your vehicle type. If you haven't connected the violet wire to a tach source in the vehicle, do so. Then program Tach. If you are trying to use virtual tach (no tach wire connected), then this may be your problem. Some vehicles like Hyundai and Kia you cannot use virtual tach on them.
-------------
sparky
Posted By: johnnygaloshes
Date Posted: October 14, 2014 at 5:04 PM
2010 Hyundai Santa Fe
It has the purple wire installed, but i will check the connection to make sure it hasn't come apart.
Posted By: johnnygaloshes
Date Posted: October 14, 2014 at 5:38 PM
Checked wire, it was still fine. Did tach learn, worked like a charm. Thanks for the help!
|