I have a Kia Rondo 06. And Im attempting to install this BullDog rs83b remote start.
When I first plugged in the red 12vt wire. The unit clicked 3 times. After checking with their troubleshooting guide, I found I needed to reprogram the remote.
I followed the directions here
https://www.bulldogsecurity.com/pdf/epromall.htm
However neither method 1 or 2 work. The unit just clicks 3 times.
Is there any thing else I can try?
Think I would double check my Chassis Ground wire, the Brake (+) wire and the Ignition 1 wire connections.
All of these are needed to be functioning for the Memory Clear to work.
As I remember, the first time you plug in the fuses after making all the required connections, the Parking Lights
should start to flash continuously. If you are doing the clear memory routine, you disconnect all harnesses from
the module for at least one minute. When you reconnect everything, the Parking Lights should start flashing.
At this point you press any button on the first remote to be paired with the control module. The Parking Lights
should stop flashing. To add another remote, you press & hold the Brake pedal, then press and hold Button 1
on the working remote until the Parking Lights flash once. Release button 1 and press any button on the new
remote. The Parking Lights should flash 3 times.
-------------
Soldering is fun!
I've created a short video of what Im doing according to what the tech support people have told me.
https://www.youtube.com/watch?v=ttP7pYK6ixc
Could you take a look and see if I am missing something?
and a minor "honorable mention" to the 12V for this suggestion...
"Think I would double check my Chassis Ground wire, the Brake (+) wire and the Ignition 1 wire connections. All of these are needed to be functioning for the Memory Clear to work." |
-------------
Soldering is fun!