2014 crv starter problem
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137655
Printed Date: May 31, 2024 at 9:11 PM
Topic: 2014 crv starter problem
Posted By: matt911
Subject: 2014 crv starter problem
Date Posted: November 11, 2014 at 7:02 AM
I attempted to install a Compustar FT-7200S-CONT with Blade-AL bypass on a 2014 Honda CRV. The blade has been flashed with firmware DL-HA3.
I followed the blade guide and connected the wires indicated
https://cdncontent2.idatalink.com/corporate/Content/Manuals/DL-HA3/BLADE-AL(DL)-HA3-EN_20141031.pdf
Ignition
CanH
CanL
Key Data
Lock
Unlock
Ground
WHITE/ Black to Blue / YELLOW
On the Compustar 7200 I connected
2x power wires
Ignition
Starter
Accessory
Ground
I then went to do the module programming but the red light stays steady indicating "Waiting for more vehicle information". So I cannot not complete the programming.
When attempting to start the vehicle with the key the immobilizer light flashes and the vehicle will not start
I removed the compustar 7200 and left the wiring connected. Still the vehicle will not start. It tries to crank and then sometimes runs for half a second and shuts down.
Could someone please help me figure this out. Thanks.
Replies:
Posted By: matt911
Date Posted: November 11, 2014 at 10:32 PM
Never mind I rechecked the connections and found one of the solder joints broke off from one of the wires on the blade harness.
|