accent 2008 + rs, cranking & not starting
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137703
Printed Date: May 19, 2024 at 2:35 AM
Topic: accent 2008 + rs, cranking & not starting
Posted By: xcessiv46
Subject: accent 2008 + rs, cranking & not starting
Date Posted: November 16, 2014 at 8:59 AM
Hello fellow DIYers,
I just installed a DBALL2 + ProStart 6-button 2-way Remote Starter (from Canadian Tire) on my canadian '08 Hyundai Accent.
- Everything is hooked up, the DBALL2 is apparently programmed based on the LED status
- I'm getting the tach status from the DBALL2, everything else directly from the car wires
- I'm getting the proper +12V on ignition and starter when remote starting
- I can hear the fuel pump when remote starting
On the other hand, the car cranks 8 secondes but does not start, even with the key in the ignition.
The car obviously starts fine when starting normally.
I also tried to press the gas pedal in case it's a fuel related problem.
Any idea?
Replies:
Posted By: howie ll
Date Posted: November 16, 2014 at 10:30 AM
Sounds like tach not learned.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|