2009 vw city golf with dball2
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137716
Printed Date: May 01, 2024 at 1:15 PM
Topic: 2009 vw city golf with dball2
Posted By: daflipcyde
Subject: 2009 vw city golf with dball2
Date Posted: November 16, 2014 at 10:32 PM
Directechs install guide says to hook up everything on VESCM. I can't find anything there. So I hooked up starter and ignition directly from ignition harness and can wires on the alarm module. Is this correct way to do it? The VESCM are the relays right? I can't seem to find the G plug. Before I program the dball2 I plug via D2D and light turns solid red but letting it sit it will start to flash red twice then back to solid red. Pressing the unlock, then turn on ignition does the same thing, solid red, flash red twice, solid red. Defective module or wrong hookup somewhere?
Replies:
Posted By: howie ll
Date Posted: November 17, 2014 at 12:36 AM
Silvery grey module half way down the steering column. VW are about the one vehicle the DB-ALL DB-ALL2 works well with.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: daflipcyde
Date Posted: November 17, 2014 at 10:24 PM
Yeah I do not see that module anywhere in this vehicle. Also should the dball2 when 1st plugged in the light is solid red flashes twice then back to solid red? This is the pattern I get. This is before programming the module to learn CAN
Posted By: daflipcyde
Date Posted: November 22, 2014 at 11:47 AM
Wrapping the key and ignition does not seem to pick up the signal very well. Are there any other way to do this? I wrapped it around ignition 5 times and on key 5 times near the front as per instructed. Does not work. It will however work if key is against the ignition barrel.
Posted By: howie ll
Date Posted: November 22, 2014 at 11:51 AM
Key at rear also flash the DB-ALL2 before programming.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: howie ll
Date Posted: November 22, 2014 at 11:52 AM
Alternative, VW dealer or decent locksmith, copy key, plain, basic chipped with no buttons for lock/unlock and use a 556U.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|