2014 kia soul remote start not working.
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137789
Printed Date: April 28, 2024 at 2:40 AM
Topic: 2014 kia soul remote start not working.
Posted By: ryan71489
Subject: 2014 kia soul remote start not working.
Date Posted: November 24, 2014 at 11:38 PM
I have just installed an AutoPage C3RS625 with an EVO ALL(I used D2D)on my 2014 PTS Kia Soul and I cannot get the vehicle to do anything when I press the remote start button. When i press the remote start button the remote beeps 3 times as soon as the button is pressed. I am not familiar with AutoPage and I am not sure if anyone else here is. I believe my EVO ALL is programmed properly.
The lock, and unlock function properly but nothing for the remote start.Any help would be greatly appreciated! I have hit a wall and I don't know what else to try at this point.
Replies:
Posted By: Chris Luongo
Date Posted: November 25, 2014 at 7:24 AM
Make sure the hood is all the way closed. Couldn't hurt to open it and close it hard.
Also, I'm not familiar with Autopage either, but pretty much every remote starter has a way to disable it when you're about to work on the car's engine, for safety. Look at the user's manual and see how to turn this feature on and off.
Posted By: ryan71489
Date Posted: November 25, 2014 at 5:30 PM
The hood was closed and doors so that wasn't the issue. I did get it to work though, just not properly. I changed the tach setting from "techometer check" to "voltage check" and then programmed that accordingly, and the vehicle will now remote start.
My new issue is that I can get in the car NOT press the ignition button and apply the brakes and the vehicle does not shut off. I can shift it into any gear and just drive away and never have to press a button.
Again I am using D2D
Thanks!
Posted By: jgarcia1925
Date Posted: December 05, 2014 at 4:57 PM
ryan71489 wrote:
The hood was closed and doors so that wasn't the issue. I did get it to work though, just not properly. I changed the tach setting from "techometer check" to "voltage check" and then programmed that accordingly, and the vehicle will now remote start.
My new issue is that I can get in the car NOT press the ignition button and apply the brakes and the vehicle does not shut off. I can shift it into any gear and just drive away and never have to press a button.
Again I am using D2D
Thanks!
do you happen to have any pictures or tips of anything that was a pain for this? ill be working a 2013 PTS, more than likely the same thing, except i will be using a code alarm RS and idatalink module. im assuming they are about the same. any other thing to look for? wiring hard to get to?
any tips are appreciated!
Posted By: djunique3
Date Posted: April 20, 2016 at 9:38 AM
I also need help on this 2014 Kia SOul push to start. using a omega OL-MDB-ALL to interface the pushtostart/immobilizer, everything is hooked up correctly, the module programs correctly, but WILL Not start the vechile. it powers up properly, but wont engage, like its not reading the fob, ( interface ),. looking/testing the interface, it is receiving GWR & activating. any sugguestions
-------------
born to install
|