Print Page | Close Window

viper 571vx problems

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137913
Printed Date: April 27, 2024 at 2:19 PM


Topic: viper 571vx problems

Posted By: edgar62902
Subject: viper 571vx problems
Date Posted: December 09, 2014 at 7:51 PM

I have a Viper 571vx remote starter installed in my 99 4runner,it has been working perfect for the last 7 years untill last week when i started and after 30 seconds it shut down and wouldn't start with the remote anymore(cranks but doesn't start).after a week playing with it trying to figure the problem out I found out it was in valet mode and took it out of valet mode and it started working good again but this morning i started with the remote and it stopped running after a minute and now it won't start with remote anymore.put it in "valet mode" and it started but only ran for 30 seconds.tried inserting the key and start it with the remote but didn't work.What make it to go in "Valet mode"? i was told the bypass may be the problem but it won't start with the key in the ignition.I looked under the dash and found a wire disconnected(it looks cut) is the violet/white wire i think is the tach wire.having the tach wire disconnected would cause the remote starter not start the car? also if i start the car with the key and press the remote buttons and remove the key it shuts off.any help please it cranks but won't start in valet or no valet mode



Replies:

Posted By: edgar62902
Date Posted: December 10, 2014 at 3:54 PM
any ideas guys?




Posted By: edgar62902
Date Posted: December 11, 2014 at 5:36 PM
BUMP




Posted By: edgar62902
Date Posted: December 12, 2014 at 11:22 AM
nobody?




Posted By: smokeman1
Date Posted: December 12, 2014 at 6:49 PM
The only thing I can think of is get out the DMM and start checking the wires for proper voltage. Check all of the connections as if you were doing a install.
Bad/loose ground? Antenna go bad? Brain? Would be nice if you had a spare part or two to swap things out with.
Just my thoughts.

-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation





Print Page | Close Window