xk05 and lexus rx350
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137926
Printed Date: June 09, 2024 at 8:11 AM
Topic: xk05 and lexus rx350
Posted By: vane0804
Subject: xk05 and lexus rx350
Date Posted: December 10, 2014 at 12:39 PM
trying to program xk05 to 2008 lexux rx350 for remote start only..wired and when following programming, found led stays on solid when plugged in. when key in cylinder, led flashes..and stays flashing..then stays on solid. then won't try programming again until i disconnect and re flash...any ideas?
-------------
~It's me!
Replies:
Posted By: tedmond
Date Posted: December 10, 2014 at 1:27 PM
if it stays solid it most likely programmed. have you tried remote starting
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: vane0804
Date Posted: December 10, 2014 at 6:47 PM
Yes...it doesn't work. it needs to stop flashing to show programming complete. flashing means in progress. I even tried switching rx and tx wires. still won't program. now won't even flash..just stays on solid. once I flip wires again..(wire them the way they were originally, no I get it flashing for about 2 minutes. still will not program. I think it may be a defective module.
-------------
~It's me!
Posted By: vane0804
Date Posted: December 10, 2014 at 6:49 PM
Yup ...it's a defective module..now I try to flash it to the same firmware again, and the computer and xk loader won't recognize it...module is fried...thanks for the reply. I tried a DBALL module...programmed easily and fast..no problems now.
-------------
~It's me!
|