2013 accord cm7200
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=138017
Printed Date: May 19, 2024 at 5:33 AM
Topic: 2013 accord cm7200
Posted By: stroker351w
Subject: 2013 accord cm7200
Date Posted: December 21, 2014 at 7:14 PM
I have the new 7200 that I'm putting in a manual transmission accord. Everything has been installed correctly and firmware has been updated and key cloned however I'm still running into a problem. I go through the sequence needed for a manual which puts it in reservation mode however I still get 7 clicks for an error which is Reservation Mode. Also, when I get out of the car it turns off but the power doesn't completly turn off. What could be the problem?
Replies:
Posted By: tedmond
Date Posted: December 21, 2014 at 8:56 PM
First off, when using a 7x00 series brain on a manual transmission, you MUST use the FT-DAS.
Secondly, what bypass are you using ? You require a tach, door pin, ebrake and brake signal connected to the 7200.
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: stroker351w
Date Posted: December 21, 2014 at 10:56 PM
I'm using the integrated blade bypass
Posted By: tedmond
Date Posted: December 21, 2014 at 11:47 PM
what do you mean by it turns off but not completely off? pts?
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: stroker351w
Date Posted: December 30, 2014 at 7:34 AM
The car powers down once the door is shut however, it says "Power On" on the dash which means the accessory power is still on.
Posted By: tedmond
Date Posted: December 30, 2014 at 7:27 PM
double check your PTS connection. it should power the car down completely. Ive done a few without problems.
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: stroker351w
Date Posted: January 09, 2015 at 12:11 PM
Do you remember what color wire the PTS was on the harness? I have the schematics but I'd like to make sure.
Posted By: tedmond
Date Posted: January 09, 2015 at 4:54 PM
the pts wire is blue (+)
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: stroker351w
Date Posted: January 10, 2015 at 3:55 PM
The car is shutting down now however when I go to RS the car nothing happens. No clicks or flashes, nothing. The lock and unlock work properly so I know the canH abd canL are correct. Generally this would mean neutral safety or something like that isn't hooked up but that's on the older remote start.
Posted By: tedmond
Date Posted: January 10, 2015 at 6:33 PM
Snip the loop, and make sure all doors are closed. If they aren't it won't remote start
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
|