08 ford fusion crimestopper rs4g5 evoall
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=138277
Printed Date: May 20, 2024 at 11:57 PM
Topic: 08 ford fusion crimestopper rs4g5 evoall
Posted By: mvaillan
Subject: 08 ford fusion crimestopper rs4g5 evoall
Date Posted: January 17, 2015 at 6:30 AM
The remote starter works fine but it don't shutt off engine when I press the brake pedal or with the parking brake disengage.
I think this signal is supposed to send to remote starter via evoall datalink (Can bus high and low). The remote and evoall are both set to use fortin protocol but I have the option to use also ADS protocol.
How can I check if the signal from Can bus is working
Thanks
Replies:
Posted By: smokeman1
Date Posted: January 17, 2015 at 11:27 AM
Might not work in this application. Connect the Brake shutdown wire to the fusion brake wire.
-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation
Posted By: mvaillan
Date Posted: January 17, 2015 at 12:04 PM
After I checked on the internet it seems that the Evo all and Crimestopper have many problems to communicate well I must wire to wire instead of using datalink.
I try to communicate with crimestopper support but I never received and answer from them.
|