dball2 flash settings
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=138299
Printed Date: April 29, 2024 at 6:04 PM
Topic: dball2 flash settings
Posted By: cormanvette
Subject: dball2 flash settings
Date Posted: January 19, 2015 at 1:34 PM
Hello all!
I'm looking to flash my DBall2 for my 2006 4Runner SR5 without an OEM alarm. I'm using it with a Viper 4706V and a 529T for my back window. My main purpose for it is to be used as an immobilizer bypass.
Are there any other settings I need to have checked/on when I flash it? Like the door locks, SS, ST, RS settings...? Or can I just uncheck them all since it's just being used as an immobilizer bypass...?
Thanks!
-------------
Nick
Replies:
Posted By: howie ll
Date Posted: January 19, 2015 at 5:37 PM
The trick is to flash it once with ALL the settings deleted, then a second time picking the settings you want. You might have to repeat this a few times.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: cormanvette
Date Posted: January 19, 2015 at 9:11 PM
Dang good to know! Thanks Howie II.
I flashed with all of them unchecked and now need help figuring out which to check before i flash it again. Below is a list of what I think I need to get the remote start working properly, the door locks, and my 529T for my back window to roll up and down. Any corrections I need to make?
DL-Lock CHECKED
DL-Unlock CHECKED
DL-Trunk
RS-Request engine coolant temp.
RS-Request vehicule speed
RS-Request intake air temperature (outside temp)
RS-Request RPM CHECKED
RS-Ground when running CHECKED
RS-Start command CHECKED
RS-Stop from remote CHECKED
RS-Starter CHECKED
RS-Ignition command
RS-Acc from RS
RS-Ignition from RS
RS-Dome light from RS
RS-Aux1 CHECKED
RS-Aux2
RS-Aux3
RS-Aux4
RS-Chirp
RS-Car finder
RS-Parking light activation
ST-Hand brake
ST-Hood
ST-Trunk
ST-Driver door
ST-Other doors
ST-Brake
ST-Key sense CHECKED
ST-Ignition
ST-Glow plug
ST-Park Neutral
OEM Keyless-disarm
OEM Keyless-arm
Hidden
ST-OBDCAN
SS-Alert Status
SS-OEM Alarm
RS-Request Runtime CHECKED
-------------
Nick
Posted By: tedmond
Date Posted: January 19, 2015 at 9:38 PM
just flash it as default no need to make changes, as the bypass is only good for transponder override. You should have bought a pkall or key-override-all. Cheaper and does the same job. This car is dated prior to the can network. Analogue connections are required.
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
|