’15 mazda 3 pts remote start issue
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=138330
Printed Date: April 28, 2024 at 4:51 AM
Topic: ’15 mazda 3 pts remote start issue
Posted By: ff419
Subject: ’15 mazda 3 pts remote start issue
Date Posted: January 24, 2015 at 11:40 AM
Hi all,
Here's the deal. I have a 2015 Mazda 3 hatchback with the smartkey/PTS system. I bought the FLCAN and avital 4103x remote starter. I have everything wired up, the FLCAN flashed and programmed through both steps.
The issue is when I push the remote start, the car powers up the accessories and gets ready to seeming crank, then shuts down... and it tries this 3-4 times. Now, if during this sequence I walk over and put my smartkey near the window where the car can sense it, then it'll start up.
The FLCAN is hardwired to the Avital and I did the programming in the hardwired mode.
Not sure what else to try. The FLCAN progresses through the programming steps perfectly and since it'll start up with the key nearby then I can't see it being an issue with the remote start.
Thanks for any help!
Replies:
Posted By: tedmond
Date Posted: January 24, 2015 at 3:02 PM
you have to redo the KLON then. Do you have an idatalink ads-usb?
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: ff419
Date Posted: January 24, 2015 at 3:37 PM
Well, it appears I've reached my key cloning limits for this module. So I'll have to wait until monday to call customer service.
Posted By: ff419
Date Posted: January 24, 2015 at 3:42 PM
Hmm, looks like my first reply didn't go through like it said. I have the flashlogic updater usb cable and have tried reflashing it a few times prior to coming here. The flash, key programming and cloning always go according to the guides. And the FLCAN blinks green during the remote start process.
Should I try the idatalink flasher page instead of flashlogics? They look identical.
I've even tried both versions earlier, the: FLC-AL(DL)-MA3 (1.4) and ADS-AL(DL)-MA3 (1.4)
But like I said, I can't flash this module anymore I guess until I can get it reset on monday.
|