2013 dodge won’t remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=138589
Printed Date: April 29, 2024 at 10:05 AM
Topic: 2013 dodge won’t remote start
Posted By: nismo_monster
Subject: 2013 dodge won’t remote start
Date Posted: March 02, 2015 at 6:24 PM
Hi I installed a viper 5906v with a dball2 on 2013 dodge ram everything works but it will not remote start the bypass is receiving all signals but still nothing any help is appreciated
Replies:
Posted By: tedmond
Date Posted: March 02, 2015 at 6:51 PM
any diagnostics?
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: nismo_monster
Date Posted: March 02, 2015 at 6:54 PM
No it just cycles the three times and then shuts down but does not give any diagnostics
Posted By: tedmond
Date Posted: March 02, 2015 at 7:03 PM
look at the number of parking light flashes. After the failed start. You must have parking lights connected or listen for relay clicks from the unit
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: nismo_monster
Date Posted: March 02, 2015 at 7:07 PM
I did but it doesn't give me any I was expecting it bu got nothing
Posted By: tedmond
Date Posted: March 02, 2015 at 8:38 PM
cranks at least?
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: nismo_monster
Date Posted: March 02, 2015 at 8:41 PM
I wish it did but no the dash lights come on and you can hear the relays cycle three times but does not crank and does not give any error codes everything else functions properly lock unlock parking lights ect.
Posted By: tedmond
Date Posted: March 02, 2015 at 9:18 PM
you should check the following. If you have no dash lights, you have an issue with the Gray/Black (+) from the DBALL2 Red connector. Verify connection to the ignition.
Secondly, check can high and can low of pin 6 and 14.
Lastly, Check the immobilizer wire and ensure you have the correct car vs connector side.
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: nismo_monster
Date Posted: March 02, 2015 at 9:23 PM
Sorry for the bad grammar I do have dash lights. It is hooked up in d2d and is running a thchd3 t harness so can bus should all be right
Posted By: tedmond
Date Posted: March 02, 2015 at 9:43 PM
if the connector isn't plugged in or has bent pins, it wont start. check ignition and turn on switch
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: nismo_monster
Date Posted: March 03, 2015 at 7:08 AM
I checked pins and didn't see any that were bent ignition switch is working fine I can start the truck activate the remote start remove the key and it will stay running just like it should it just won't do initial start up the truck won't be back until next week! I want to than you for all your help so far and any more to come
|