2013 honda civic door unlock while engine on
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=138662
Printed Date: April 27, 2024 at 12:28 AM
Topic: 2013 honda civic door unlock while engine on
Posted By: Lubrano
Subject: 2013 honda civic door unlock while engine on
Date Posted: March 14, 2015 at 8:14 PM
Just finished installing a vper 5706v in a 2013 honda civic using a DBALL2. The problem s I can not get the doors to unlock while the remote start is running the car. I connected the 3 pin connector green and blue wires on the 5706v to the blue and green wires on the black connector on the dball2. Through the can data bus the doors work perfect when NOT in remote start.
I have tried to use the BLACK/ white and GREEN/ black on the red connector on the dball2 but dont know where they would go. I see it says gray pin 18 and blue pin 11 but i must be blind. Having a hard time finding those wires on a blue connector. It does not look anything like the one on the dball installation page. Then I thought of using the blue and green 3 pin right out of the 5706v straight to the car but I could not locate which wire on the vehicle would lock and unlock the doors over riding the body control module in the car.
Please anyone who knows how to make this work let me know. Thank you.
Replies:
Posted By: Lubrano
Date Posted: March 14, 2015 at 9:07 PM
I found the blue connector way up there. All done thank you.
Posted By: shark mobile
Date Posted: March 16, 2015 at 8:15 PM
Glad you found it....the tiny door lock wires are in a grey taped harness that runs up under the dash right beside the DKP....test and tag!
-------------
Solder, tape, repeat!
|