2011 chevy cruze, Dball2
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=138744
Printed Date: April 27, 2024 at 3:22 PM
Topic: 2011 chevy cruze, Dball2
Posted By: digitalcustoms
Subject: 2011 chevy cruze, Dball2
Date Posted: March 30, 2015 at 11:57 AM
Anyone know the trick to getting one of the POS's to remote start? Wired up according to xpresskit type 1a install and I can only get it to start if i start it with a key, turn it back off, and immediately press the remote start button. If I don't start it with a key first it turns on dash lights and that's it. Does not do anything different having key near or in cylinder. I install dball modules on multiplex gm vehicles often, never had any issues till this one. Vehicle is an automatic so i don't have the clutch wires connected, no ebrake, no tach, and no rap off. Any ideas would be greatly appreciated.
Replies:
Posted By: digitalcustoms
Date Posted: March 30, 2015 at 12:00 PM
Also this car is wierd, when testing the ACC wire, it turns on the dash lights and chime that normally come on along with ign.1. when i power up ign.1 it seems to just prime the fuel pump or something. Seems backwards from any other gm I've ever installed in.
Posted By: cruze625
Date Posted: March 21, 2016 at 3:16 PM
Did you figure this out?
|