Manual roll up and down
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=138995
Printed Date: May 02, 2024 at 7:05 AM
Topic: Manual roll up and down
Posted By: hondaguy48891
Subject: Manual roll up and down
Date Posted: May 20, 2015 at 8:08 PM
Hello all, Im trying to figure out how I can wire the windows to go up and down manually with the 2 aux outputs. I have relays powering the windows currently due to a short in the factory harness. How would I wire them so they don't work together when using the door switches? Any help on this would be greatly appreciated. thank you in advance
Replies:
Posted By: howie ll
Date Posted: May 21, 2015 at 8:41 AM
Vehicle make and model? It would help.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: howie ll
Date Posted: May 21, 2015 at 8:42 AM
How are the relays wired, NEG (-) or POS (+) trigger at the relays.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: hondaguy48891
Date Posted: June 23, 2015 at 8:37 PM
Im sorry...I have a 1993 explorer and the power windows and locks stopped working so they were rewired with relays in the reverse polarity way and Im just looking for a way to wire them to roll and up and down with the key fob of my Skytec G25 keyless entry system.
Posted By: howie ll
Date Posted: June 24, 2015 at 4:21 AM
Look at my second post AGAIN.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: hondaguy48891
Date Posted: July 21, 2015 at 9:24 PM
positive triggers to activate relays...30 to the motors and 87a is ground...just a basic reverse polarity setup...should have included all this in the original post but it didn't occur to me that it was this important...forgive my absent mindedness LOL
Posted By: howie ll
Date Posted: July 22, 2015 at 4:10 AM
OK this is how I assume they're wired:- pos_relay_window_switch.png
This shows you what to do:-
pos_relay_window_switch_v2.png
This show NEG switching which was the proper way (failsafe) to do it initially:-
neg_relay_switch.png
Now see how much simpler it is with NEG switching:-
neg_relay_switch_v2.png
The diodes shown are mandatory. (1N4004). ------------- Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|
