Print Page | Close Window

Viper 5706 No Door Lock\Unlock

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=139189
Printed Date: May 02, 2024 at 5:01 PM


Topic: Viper 5706 No Door Lock\Unlock

Posted By: tron77
Subject: Viper 5706 No Door Lock\Unlock
Date Posted: July 12, 2015 at 2:05 PM

Hi crew,
 I have fitted my Viper 5706v (Basic- alarm only, i intend to do remote start some other time) into my Nissan Patrol GU3, but are having troubles with door lock\unlock not working.
Initially a Vision VAE 318-1800 alarm was inplace,,, So I decided on a changeout to a new Viper. Everything is working as intended apart from door locking\unlocking,,, going from the Vision VAE318 wires already installed & the wire diagram,,, show that remote locking was pins 30 Green\Yellow - Lock "C" & Blue\Yellow pin 33 Unlock "C". I wire these to resemble what was initially installed on the Vision VAE318 as to resemble to the VIPER (Door Lock 3 pin connector),,,,,PIN30= GREEN (-) 500mA LOCK OUTPUT & PIN33= BLUE (-) 500mA UNLOCK OUTPUT...BUT NO go. Any ideas would be appreciated.
posted_imageposted_image
posted_image



Replies:

Posted By: tron77
Date Posted: July 12, 2015 at 7:43 PM
Awesome problem solved...

Here is a pinout of the keyless entry module for anyone wanting to know, I removed the module altogether and spliced\soldered into the wires shown in the picture. Everything you need to replace it is right here, the BLACK/ red and BLACK / YELLOW wires can be used to trigger the door lock relay (negative trigger) and if you have moved the blue and blue/red wires to the door lock relay it will work just fine.
[IMG]uploads/B35_plug#2.jpg[/IMG]





Print Page | Close Window