Viper 5706V with Shock Sensor 504D

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=139313
Printed Date: April 30, 2024 at 1:13 AM

Topic: Viper 5706V with Shock Sensor 504D

Posted By: stanward
Subject: Viper 5706V with Shock Sensor 504D
Date Posted: August 16, 2015 at 4:10 AM

I noticed the wiring harness that came with the 504D has the green wire jumpered to the blue wire (on one end). And on the other end, the green wire is just hanging there.

Do I cut the green jumper and connect to the hanging (green) wire?

**I noticed that my old 504D (had a spare from a previous project), does not have the green and blue wires jumpered.

Replies:

Posted By: dairyboy3
Date Posted: August 16, 2015 at 2:13 PM

Do not cut the loop. The loop goes on the sensor side. The extra green wire is for an additional sensor. If you don't have one then don't use it.

Posted By: stanward
Date Posted: August 17, 2015 at 2:52 AM

Thanks for your response.

So which side of that harness goes to the sensor?

Print Page | Close Window