2010 wrx idatalink problem
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=139411
Printed Date: May 14, 2024 at 9:10 AM
Topic: 2010 wrx idatalink problem
Posted By: scooby2573
Subject: 2010 wrx idatalink problem
Date Posted: September 08, 2015 at 6:41 PM
I have a 2010 wrx hatchback I installed an avital 4103 remote start into. I used the dbi-ali sub-en doorlock interface in data mode. Everything works great except it wont relock the doors after it remote starts. I've gone thru the programming and it is set up to relock after start, but it wont do it. Anyone have any ideas?
Replies:
Posted By: howie ll
Date Posted: September 09, 2015 at 5:09 PM
Is there a ignition key on this vehicle? If so have you rigged up a relay to convert dark blue status output to run the vehicles keysense? A wire that goes to POS (+) when you insert the key?
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: scooby2573
Date Posted: September 10, 2015 at 6:32 AM
It does have a key. I will try that tonight. Thank you!
Posted By: howie ll
Date Posted: September 10, 2015 at 6:37 AM
Think it's BLACK/ white, goes POS (+) when key is inserted.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|