Adding a LED for deterent

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=139501
Printed Date: May 04, 2024 at 9:12 AM

Topic: Adding a LED for deterent

Posted By: kw4tx
Subject: Adding a LED for deterent
Date Posted: October 01, 2015 at 7:18 AM

I have a viper 4105v with a smart start installed...

I would like to have a blinking light when I lock the doors like I have on my other vehicle which has a Viper 5101

How can I hook up an LED to flash when the doors are locked and not flash when unlocked

Is this possible? Or very difficult?

Replies:

Posted By: chev104275
Date Posted: October 01, 2015 at 9:47 AM

You could buy a flashing LED and wire it to the Orange Ground when locked wire pin 5 on the 9 pin harness.

Flashing Led

-------------
If i Can't Install it I Don't need it Joe

Posted By: davep.
Date Posted: October 01, 2015 at 10:15 AM

You can also have a flashing LED even without an alarm. I've done a couple of these this way: Use a flashing LED. Wire red (+) to Hot at All Times. Wire the (-) to any wire that is hot in IGN. When the IGN is on, + on both sides = LED off, but with IGN off, the IGN provides ground for the LED. If the vehicle has DAB, connect the (-) of the LED to the DAB. Then the LED won't flash until a door is opened, or the DAB times out.

Print Page | Close Window