DEI 2102T
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=140597
Printed Date: April 27, 2024 at 5:14 AM
Topic: DEI 2102T
Posted By: kulblue
Subject: DEI 2102T
Date Posted: January 07, 2016 at 6:25 PM
I had Avital 5303L and DBALL2 on my Accord 09. I tried to install the DEI 2102T but no luck to lock or unlock the Accord. I did is plug-in the Antenna and D2D then pairing the fob.I need to flash the DEI 2102T? Someone can help me? I apperciate it. Thanks
Replies:
Posted By: kulblue
Date Posted: January 09, 2016 at 12:54 AM
I need to pairing the pke from Avital but I don't know how to do it. Someone can help me? Thanks.
Posted By: northern
Date Posted: January 09, 2016 at 5:48 PM
What did you find out? I am looking at ordering a few of these, but if people are having problems I might step back
Posted By: kulblue
Date Posted: January 10, 2016 at 1:24 AM
Still can't figure it out how to do the pairing. No luck yet. I hope some one can help.
I tried The Type 1 Diagram and works fine. Just need to pairing the pke system to remote starter module/Avital.
Posted By: northern
Date Posted: January 11, 2016 at 3:27 PM
Did you try DEI tech support? Although I believe they are the worst in the industry sometimes they are able to lend a hand.
I think im just going to buy a few of them since they only cost $30.
Maybe I'll check around the directed dealer forums for better responses.
Posted By: smokeman1
Date Posted: January 11, 2016 at 4:28 PM
I don't see anything in the instructions for connecting to a Avital 5303. Are you using a 8210 universal adaptor?
Which type setup are you using?
Instructions on Page 23:
1. Place the remote starter in paring mode.
2.Press and hold the programming button on the PKE(2102t). The LED will flash 3 times to confirm that data is being sent to the remote starter,
3. Release the programing button. The remote starter will confirm the remote learning operation.
-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation
Posted By: kulblue
Date Posted: January 11, 2016 at 4:35 PM
northern wrote:
Did you try DEI tech support? Although I believe they are the worst in the industry sometimes they are able to lend a hand.
I think im just going to buy a few of them since they only cost $30.
Maybe I'll check around the directed dealer forums for better responses.
Never try yet to contact DEI. Pls! lmk if you get info.
Posted By: kulblue
Date Posted: January 11, 2016 at 4:49 PM
smokeman1 wrote:
I don't see anything in the instructions for connecting to a Avital 5303. Are you using a 8210 universal adaptor?
Which type setup are you using?
Instructions on Page 23:
1. Place the remote starter in paring mode.
2.Press and hold the programming button on the PKE(2102t). The LED will flash 3 times to confirm that data is being sent to the remote starter,
3. Release the programing button. The remote starter will confirm the remote learning operation.
Im using the Type 2a diagram and I bought the 8210 adapter.
How to do the remote starter in pairing mode?
Turn on key position. press and release valet switch then press and hold the valet switch, siren chip once then relaese the valet switch. Means is pairing mode?pls lmk if I did it right. I tried that but no luck. Maybe I did it wrong way. Thanks for reply.
I never hook up any of the 10-pin white connector from 2102t. I thought the D2D will do everything.
Posted By: smokeman1
Date Posted: January 11, 2016 at 6:43 PM
Again, don't know if this will work with the 5303.
Maybe you could try changing the RF Protocol of the 2102, listed on page 21 of the instructions, then try pairing the 2102 with the remote starter.
Paring instructions for the 5303 are in the install guide.
-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation
Posted By: kulblue
Date Posted: January 12, 2016 at 2:35 AM
I did that too. I program it first then pairing it but still no luck.. I will try on my odyssey I had python 5303p and dball.. The python 5303p same like avital 5303L. But I will give it a try maybe will work...
Posted By: northern
Date Posted: February 05, 2016 at 5:26 PM
Any luck? Are these things just junk? Dealer cost on them is around $25?
Posted By: kulblue
Date Posted: February 05, 2016 at 6:20 PM
I called DEI the installer said need to program to DEI installer.
I just do the standalone with my Avital remote start only. Works good
Posted By: kulblue
Date Posted: February 20, 2016 at 8:12 PM
|
