2014 Honda CR-V with Viper 4806V and DBALL

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=141210
Printed Date: April 29, 2024 at 4:29 AM

Topic: 2014 Honda CR-V with Viper 4806V and DBALL

Posted By: beedix
Subject: 2014 Honda CR-V with Viper 4806V and DBALL
Date Posted: April 28, 2016 at 1:16 PM

Hoping I could get a little help with a couple of connections. Planning to use D2D for this install and I'm using the DBALL installation diagram.

1) Diagram shows (-)Parking Lights on the remote start. I found a 1 page install guide for the 4806 and I don't see this connection identified on the remote start end of things.

2) Diagram shows (+)Accessory 2 on the remote start. (+)Accessory is the Orange wire in the 8-pin connector I believe. I did not see more than this one positive accessory in the install guide. Should I connect it to both 1 and 2 in the ignition?

Replies:

Posted By: kreg357
Date Posted: April 28, 2016 at 2:41 PM

The Viper has a thick Pink/White IGN2 output that is programmable to Accessory2. See Menu 3, Item 8, Option 2. This can be used to properly power the CR-V's ACC2 circuit.

The Viper H/5 WHITE PIN 30 of LIGHT FLASH RELAY is the Parking Light output wire. There is a Jumper/Fuse inside the Viper to select to polarity of the output.

-------------
Soldering is fun!

Posted By: beedix
Date Posted: April 28, 2016 at 3:40 PM

Thanks, that's very helpful.

Do you happen to know if the polarity selection jumper defaulted to negative?

Posted By: kreg357
Date Posted: April 28, 2016 at 10:13 PM

No, usually it's set to (+) but sometimes falls off during shipping... posted_image

-------------
Soldering is fun!