One diode for two window modules?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=141385
Printed Date: May 03, 2024 at 12:29 PM
Topic: One diode for two window modules?
Posted By: reelizmpro
Subject: One diode for two window modules?
Date Posted: June 09, 2016 at 12:13 AM
I am in the middle of installing two 535T window modules on my convertible. My Omega K9 alarm has a starter kill on the orange wire (ground when armed). I spliced into the orange wire and diode isolated (band facing alarm) the new wire. My question is can I run this isolated wire to both modules OR do i have to further isolate the modules from each other? I figure it should be fine since they are just accessories and not sensors that activate the alarm. Thanks.
Replies:
Posted By: reelizmpro
Date Posted: June 10, 2016 at 6:19 PM
Welp I figured it couldn't hurt to diode isolate everything so I went ahead and isolated the starter kill relay and the two 535T's with the stripes going toward the alarm.
I have a major problem...
The one touch UP/DOWN works perfectly but when I arm my alarm the windows roll DOWN instead of UP. The windows vent UP instead of DOWN. I checked my wiring and the one touch works right so it's not the window wiring. Any ideas?
Posted By: reelizmpro
Date Posted: June 11, 2016 at 4:17 PM
Figured it out. I switched the GWA orange wire and the gray aux wire. Works perfectly now.
|