CS310I command start troubleshoot
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=141663
Printed Date: May 15, 2024 at 5:39 AM
Topic: CS310I command start troubleshoot
Posted By: blaster45
Subject: CS310I command start troubleshoot
Date Posted: August 30, 2016 at 5:30 PM
I have the cs310i in my 2001 duramax 2500 and the in line 30amp fuse keeps blowing. I have checked the wiring over and can't see any problems with shorting but anytime I go to put the fuse in, it blows. It's worked before but I tried one day an found the fuse blown. Is there anytime else to check?
-------------
Replies:
Posted By: lurch228
Date Posted: August 31, 2016 at 4:34 AM
Sounds like a stuck internal relay, probably the ignition or starter output.
Posted By: blaster45
Date Posted: August 31, 2016 at 4:42 PM
I just checked the ignition and starter relay and both work good. Open an close fine. Could it be the ignition switch?
Posted By: lurch228
Date Posted: August 31, 2016 at 8:44 PM
Would have to be a short to ground typically if it's blowing a 30A fuse. Is it the RED or the RED / Black that is blowing?
Try unplugging the heavy gauge wire plug before replacing the fuse, then plug it back in once you have replaced the fuse!
Posted By: blaster45
Date Posted: August 31, 2016 at 9:41 PM
It is the red one that kept blowing. But I reset the box today and plugged the fuse in an i got power through without a blown fuse. Just have to fix the hoodpin switch and I think it might work.
Posted By: lurch228
Date Posted: August 31, 2016 at 9:50 PM
sounds like the brain got stuck.
|