Print Page | Close Window

2016 Chevrolet Silverado 12v for remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=141787
Printed Date: May 02, 2024 at 4:52 AM


Topic: 2016 Chevrolet Silverado 12v for remote start

Posted By: chev104275
Subject: 2016 Chevrolet Silverado 12v for remote start
Date Posted: September 27, 2016 at 5:55 AM

Is there a place inside the cab to grab power for a remote start ? I was thinking at the bcm but I wanted to see what someone that has done these trucks would use.

Thanks Joe

-------------
If i Can't Install it    I Don't need it   Joe



Replies:

Posted By: smokeman1
Date Posted: September 27, 2016 at 8:59 AM
Omega Wire:

Constant 12 volts RED / VIOLET (20A) BCM BLUE 27 PIN CONN, PIN 4 *
* BCM (Body Control Module) is located under the driver's side dash.

Have not done one myself.

DirectWire also lists it at:
12Volts, RED / purple(20A) + BCM under drivers dash, blue 27 pin plug, pin 4....and...
second 12volts, RED / blue(20A) + BCM under dash, white 26 pin plug, pin2



-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation




Posted By: chev104275
Date Posted: September 27, 2016 at 9:08 AM
Thanks smoke man that's what I had as well. I just haven't done one of these and i didn't know of there was a preferred spot to grab 12 from.

-------------
If i Can't Install it    I Don't need it   Joe




Posted By: lurch228
Date Posted: September 27, 2016 at 9:22 AM
If the wire you are trying to feed comes from the BCM then the Power wire(s) feeding the BCM are ideal, just split the load up on the BCM feed wires. If you need to power 3 feed wires and the BCM has only 2 Feed wires Hook the R/S Ignition feed up to one and the R/S Accessories to the other. IF the BCM has 4 feed wires use one of each for your R/S feeds. The more you can split the load up the better. You cant go wrong following what the OEM has already done. Since by adding a R/S you are coping what the Key and BCM does to start the vehicle.





Print Page | Close Window