2013 Santa Fe Sport smart key

Hello everyone I'm trying to do a viper auto start and dball2 install on my pregnant wife's car I found the wiring for the dball2 but not for the Santa fe sport smart key can anyone help me out please

https://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.aspx

https://www.commandocaralarms.com/wiringsearch.asp

-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation

First link is for my car 2013 Santa fe sport with smart key I have also all the wire's hooked up but can't for the of me find the redefoger wire and it's not in any articles I've seen even in the ones you just sent me thanks for the reply anyone else care to help I really appreciate it

Rear Defrost GREEN\ORANGE (- LATCHED) UNDER DASH FUSE BOX - BLUE 31 PIN CONNECTOR PIN #14



-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation

Thanks very much will check it out tomorrow. Do you happen to know dome light supervision.

There is no blue 31 pin connector by the fuse box I have a 2013 Santa fe sport 2.0t with smart key

Info from DirecTech wire listing

Santa Fe North America:
Rear Defroster GREEN/ orange (rear defroster); blue/orange or blue (front deicer) - latched dash fuse box, blue 31 pin plug (A), pins 14, 12

Santa Fe, (Smart Key) North America:
Rear Defroster GREEN/ orange (rear defroster); blue/orange or blue (front deicer) - latched dash fuse box, blue 31 pin plug (A), pins 14, 12


No Wire listing for Santa Fe Sport Smart Key.

Maybe this plug
fuel_pump.jpg

-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation

Dose that website have horn honk output wire

Same info as on the bulldog site.

HORN GRAY (-) @ DRIVERS KICK, BLACK 46-PIN PLUG, PIN 30

-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation

I got system up and running great until I tried to program the second remote after I got it programed the car keeps trying to start it self and will not shut off I had to pull the fuel pump fuse to shut it off. With auto start harness installed the car will try and start it self over and over again any ideas on what would cause this issue

If you step on the brake pedal, it should stop the remote start system.
Provided it is connected properly.
Might want to list your wire connections, model of Viper so we know what we are dealing with.

-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation

Brake shutdown worked before this issue and didn't work after and the remote start button the thing had a mind of its own can list connections when I pullbit all out again. Can someone list a full list of what wire I need to hook up with a viper 4806v and dball2

Where you trying to do this as D2D or W2W?

It would help if you listed your connections.
Was DBALL2 Flashed with correct firmware?
Did it program correctly?

-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation

I followed a guide on directechs for dball2 and my spicific car i did have the unit flashed I saw it program all if it completed. I've never really used a dball2 before and I've only wired or 7 systems total. I'm pretty sure it's wire w2w because I'm not using the harness that connects the two I don't really know much about this setup and could use some information on how to properly wire it up. I don't know the diffence between did or w2w or why I would want to use one or the other I just went on directed website typed in dball2 and my year make and model 2013 hyundai Santa fe sport 2.0t with smart key. Im trying to surprise my pregnant wifew for Christmas and I work a ton of hours the next time I can look at the wires will be Thursday. I don't even think I have the autostart harness wired with all the right wires the only ones that where in that guide was the fat pink and the starter wire and auto start didn't work till I hooked up the 3 wires with the fuses also I don't have the ground wile running wire hooked up and not sure if I need it or not so that's why I asked if someone had a wiring guide to follow

Any one have a directed vehicle print out for 2013 Santa fe sport smart key

Waiting on a listing of your wire connection from the DBALL2, Viper, and your vehicle.

-------------
When all else fails, Read the Instructions
Support the12volt.com Make a Donation

Thanks for trying to help I cut everything out bought all new stuff and went to local installer shop I can't wait anymore and I can't figure it out on my own paid way to much for this but need it for my wife and can't find good enough wire diagrams and information on what I need to do so I'll for once in my life have someone else do my work for me then go back and make everything nice and need when I get it back