2017 Hyundai Tucson lock motor wire
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=142526
Printed Date: May 15, 2024 at 1:11 PM
Topic: 2017 Hyundai Tucson lock motor wire
Posted By: sbarr
Subject: 2017 Hyundai Tucson lock motor wire
Date Posted: February 02, 2017 at 9:04 AM
I would like to utilize the lock motor wire for my remote start activation signal. It is a 2017 Hyundai Tucson, push to start. All I can find is I'm looking for an orange wire. Is anyone familiar with this wire and/or its location? Thank you.
Replies:
Posted By: chev104275
Date Posted: February 02, 2017 at 1:55 PM
This for a 16 I'm not sure if it's the same
LOCK MOTOR WIRE ORANGE (5-Wire Type) @ DASH FUSE BOX, (WHITE, 20-PIN PLUG(E), PIN 9
-------------
If i Can't Install it I Don't need it Joe
Posted By: sbarr
Date Posted: February 02, 2017 at 9:04 PM
Thank you for your reply. My remote starter requires a (-) pulse, programmable from 1 to 4 pulses. If I'm looking at the vehicles system correctly the lock motor orange wire (5 wire) is more complex than I need. I simply need a (-) pulse for each press of the Lock button on the factory remote. Unfortunately I did not realize I could've programmed the module when using the data setup to receive a three pulse lock signal for remote start. The module came pre-programmed from the supplier, it's probably not worth sending it back to have it reprogrammed.
Thank you, sbarr
Posted By: chev104275
Date Posted: February 03, 2017 at 5:53 AM
You can use a relay to invert the polarity from (+) to (-). Look in the relay section here.
-------------
If i Can't Install it I Don't need it Joe
|