2004 silverado p 5706v with gmdlbp
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=142815
Printed Date: April 28, 2024 at 10:01 AM
Topic: 2004 silverado p 5706v with gmdlbp
Posted By: mikes chevy
Subject: 2004 silverado p 5706v with gmdlbp
Date Posted: March 30, 2017 at 4:33 PM
Can any one break down where all the wires specifically go between the gmdlbp and the 5706p alarm. I got door locks and power gnd obviously. Some of the wording for the others is misleading. Thanks.
-------------
Michael
Replies:
Posted By: mikes chevy
Date Posted: March 30, 2017 at 4:45 PM
It's a crew cab 5.3. Has factory power locks and alarm. I had it all working but one thing it was doing was locking on 1 press of unlock from remote. Then unlock with a second press of unlock. ?
-------------
Michael
Posted By: kreg357
Date Posted: March 30, 2017 at 6:50 PM
GMDLBP Viper
Brown Dark Blue @ 24 Pin (-) Status Output
Green Green @ 3 Pin (-) Lock
Blue Blue @ 3 Pin (-) Unlock
Violet/White not used
Violet to truck ODB2 Pin 2 Data
Pink/White Green @ 24 Pin (-) Door Trigger input
Pink GRAY/BLACK (-) @ BCM, BLACK PLUG, PIN E Set Mode 6 to (-)
Orange not used **
Red Red @ 6 Pin +12V
Black Black @ 6 Pin Chassis Ground
** If you have a 4 door truck, you will need to add the rear door triggers into the GMDLBP Pink wire. I would diode
isolate those truck wires. Here is the info :
Driver's Rear Door Pin LT BLUE/BLACK (-) @ BCM VIOLET CONN, PIN A3 (ALL MODELS)
Pass Rear Door Pin LT GREEN/BLACK (-) @ BCM VIOLET CONN, PIN A2 (ALL MODELS)
You might try a reset on the GMDLBP, set the Type to 4 and program to the truck.
-------------
Soldering is fun!
Posted By: mikes chevy
Date Posted: March 30, 2017 at 10:39 PM
THANK YOU! I'm going to try this in the morning. I think the ones I was having trouble with was the status. And the 2 pinks. Thanks again. I'll reply results.
-------------
Michael
Posted By: mikes chevy
Date Posted: April 15, 2017 at 11:16 PM
hey kreg357, I really appreciate your help. Kids and work have delayed this install,i finally got around to finishing those wires and the locks are working good now. the only thing im having a bit of trouble with is the remote start. it remote starts just fine, but after about 10 seconds the factory alarm goes off and kills the engine. it didnt do this before? i tried hooking up the violet white on the gmdlbp to the green w/black of the 5706. no difference. what should i be looking at now? thanks
-------------
Michael
|