not working APS57E - 2004 dodge ram 1500
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=143023
Printed Date: May 02, 2024 at 2:08 PM
Topic: not working APS57E - 2004 dodge ram 1500
Posted By: 04dodgeram1500
Subject: not working APS57E - 2004 dodge ram 1500
Date Posted: June 01, 2017 at 2:26 PM
sorry about caps, it was a copy/paste
aps 57e - 2004 dodge ram 1500 4.7
no existing factory alarm system that i am aware of.
tried the key in tumbler twice and only unlocks drivers door.
14 pin main harness
green/orange-tachometer not connected
green/yellow-glow plug not connected (not diesel)
dk blue trunk release not connected
brown/black (+) inhibit brake switch white/tan connected at
brake switch
brown () inhibit brake switch not connected
grey () inhibit neutral start switch not connected
black/yellow () pulse during crank output not connected
black/red (-) pulse after shutdown output not connected
black/blue (-) pulse before start output not connected
black/lt green (-) pulse after start output not connected
lt blue (-) ground while running output not connected
grey/black (-) inhibit shutdown hood sw connected and
checked working properly (not grounding to frame)
black/white (-) horn output dark green/purple (steering
column) working properly horn honks when lock/unlock
6 pin power start harness
blue ignition 1 (+) connected pink/white
red/white battery 1 (+) connected red wire #1
green ignition 2 (+) connected pink/green
purple accessory (+) connected to blue wire (ac blower)
red battery 2 (+) connected red wire #2
yellow starter output connected yellow wire starter
4 pin 2nd main harness
black chassis ground (-) grounded to chassis
white/red parking light input (-) grounded to chassis
yellow/black to controlling alarms ignition input not
connected
white parking light output (-) white/light green at headlight
switch with 330 ohm
(parking lights are working properly both by themselves and via the remote start. blinking with lock and unlock)
2 pin door lock output harness
red door lock connected single wire system with correct
resistor
green door unlock output connected single wire system with correct resistor.
(door lock and unlock working properly with remote control)
the remote start is not working properly when i press the trunk button twice in 5 seconds. what happens is the parking lights flash 7 times.
does it need to be programmed?
do i have something wired incorrectly?
is there something else that must be hooked up that isn't?
thanks in advance.
Replies:
Posted By: 04dodgeram1500
Date Posted: June 01, 2017 at 5:15 PM
Hooked up the tach wire to the negative on the number 1 coil pack. Taught the starter how to "learn the tach" boom, done. Figured it out.
|