Viper 4706v Status Light Won’t Turn Off

Trying to install a 4706V paired to a fortin evo-all (with their t-harness) remote start system into a 2015 Jeep Compass (auto). I got the bypass programmed successfully, but for whatever reason the status LED on the viper's control center module stays constant blue, and doesn't turn off unless I completely disconnect the viper unit. The remotes that came with the kit aren't paired (it's a refurb kit), so I can't even try to take it out of valet mode. However, I had a spare viper brain of the same model laying around, and when I swapped that in, it did the same thing, which has me thinking it's not in valet mode.

The only thing that I can think of is that the Fortin diagram says that the 12v from the T harness (and by extension, the ignition switch) only supplies 10a max. Otherwise I followed this diagram to a tee. Would that not be enough amperage for the viper kit?

Connection A on the following pdf https://cdn02.fortin.ca/download/28831/evo-all_evochrt5_p20160902-2.pdf

Bump, anyone have any ideas? Kinda caught in a situation, this is supposed to be for someone else's car and I need to install it asap

Key ON, Key OFF, push button. << Another way to get out of Valet Mode without a remote.

There are a couple of antenna / control center models. They are not interchangeable. You mention "refurbished". Perhaps you were given the incorrect antenna for your module?

All the cables fit together but it did look different than the ones I usually get with these kits. I'll look around and see if I can find a model similar to the ones that usually come with these kits