2019 GMC 1500 PTS, CompuStar 7200 Remote Programming
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=147777
Printed Date: May 10, 2024 at 2:13 PM
Topic: 2019 GMC 1500 PTS, CompuStar 7200 Remote Programming
Posted By: bat9905
Subject: 2019 GMC 1500 PTS, CompuStar 7200 Remote Programming
Date Posted: October 15, 2023 at 9:14 PM
2 issues with a compustar 7200/ T13
remote on gmc 1500. Can’t seem to cycle ign on/5 times with pts to program remotes. Programming instructions suggest hitting pts button twice, however ign will not cycle on unless I hold it for 5 sec.
Second issue no park light flash when arming and disarming.
I used cn 5 green w white 250 ma output to Bcm white connector pin 22 green w grey
Thanks for any help
-------------
bat9905
Replies:
Posted By: chev104275
Date Posted: October 16, 2023 at 11:57 AM
If you can't get the Ignition to cycle fast enough using the start button. I would use a fused jumper and power the ignition Maunally to simulate the button presses. I have a setup with an inline switch to do this easier.
Parking Lights - Green/Gray - BCM under driver dash, white 26 pin plug, pin 22 Did you test this with a meter? To make sure you had the correct wire?
-------------
If i Can't Install it I Don't need it Joe
Posted By: bat9905
Date Posted: October 16, 2023 at 2:10 PM
Thank you i will try that ign jumper. ill meter the parking light wire.
-------------
bat9905
Posted By: silvercivicsir
Date Posted: October 17, 2023 at 10:08 AM
or you try, ignition on, off and brake three times, and then press lock... or put the truck in netural, and try cycling the ing on/off 5 times and then press lock. *(this works for hondas, never tried with a chev)*
Posted By: bat9905
Date Posted: October 17, 2023 at 4:29 PM
Ok so got the remotes programmed as trivial as it’s sounds. Local tech told me to start vehicle, shut off, restart, and then hit brake 5 times and hit lock lock button on each remote. That worked but seemed strange since it seems to be same as Ign on cycle. I confirmed parking light wire goes to ground when switch is on with meter. Still no flash though. I wonder if there is an option to program this in cm 7200 controller. Has anyone had issues with proximity locks option?
-------------
bat9905
|