AutoStart AS-1774SR Remote Start Not Working

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=147930
Printed Date: May 14, 2024 at 3:19 AM

Topic: AutoStart AS-1774SR Remote Start Not Working

Posted By: johnsub2013sti
Subject: AutoStart AS-1774SR Remote Start Not Working
Date Posted: February 20, 2024 at 4:50 PM

Hey everyone,

I'm hoping someone more knowledgeable than myself with remote start systems could help me (the bar is extremely low)
https://www.directeddealers.com/manuals/QG/Autostart/2W-NGRF-LCD-A-M_AS-2482TWSU_D2105_qg_uni_en_h60s60_PGa20131010.pdf

I have a Autostart AS-1774SR installed in my car, a 2013 subaru wrx sti (manual transmission).
The system came with the car when i bought it.
The remotes will unlock and lock the doors, open the trunk, but the remote start system will not work. I don't think the car is going into ready mode

I Checked which wires are connected and below yellow highlights are the ones wired to something
posted_image

1. Is the reason the remote start not working because the tach and brake switch arnt wired ?
2. When they say brake switch is it the parking brake or brake
3. There is a lot of output wires not connected. Were they replaced by the Xpress bypass

https://www.the12volt.com/installbay/forum_posts.asp?tid=137181

Tachometer RED / white to WHITE/ green ac cluster, wh 40P plg, pin 30 or ECM bhnd glv box, wh35P plg(B), pin15
Parking Brake gray - BIU right of steering column, white 35 pin plug (C), pin 32

Thank you to anyone that helps!

Replies:

Posted By: silvercivicsir
Date Posted: February 22, 2024 at 9:29 AM

how are you trying to enter ready mode? start the car, with engine running,apply FOOT brake, and apply ebrake, release foot brake. grab remote and press lock / unlock or start, and park lights should flash.. turn key off car stays running, get out, shut door, and then press lock. as long as no door is opened, you can remote start the car.

Posted By: johnsub2013sti
Date Posted: February 26, 2024 at 6:21 AM

I've tried to do the above procedure you described to get to ready mode and it doesn't work

Posted By: johnsub2013sti
Date Posted: March 02, 2024 at 12:55 PM

https://fortin.ca/download/57421/EVO-ALL_IG_REG_BI_SUB-FORESTER-IMPREZA-WRXSTI_2009-2010_KEY_A_57421.pdf

Update i found out that both the tach and brake switch are not connected to the can bus interface either. Do i need to connect them to both the can bus interface and remote start ?