Code Alarm Remote Start F50, 2002 Dodge Caravan

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=1727
Printed Date: May 04, 2024 at 4:11 PM

Topic: Code Alarm Remote Start F50, 2002 Dodge Caravan

Posted By: atrevino
Subject: Code Alarm Remote Start F50, 2002 Dodge Caravan
Date Posted: July 05, 2002 at 9:21 PM

Does anyone know if any of the ignition outputs of a code alarm brand remote start F50, has the ability to act as a pulse instead of a constant 12 VDC. I am having problems with my 2002 Dodge Caravan install. Only with the A/C not coming on. The starting part works fine. However, when the ignition output from the module activates the relay to shunt the starter 2 wire to ground via a 180 ohm resistor, the ignition does not release the relay to allow the radio and A/C to kick on. Any ideas would be greatly appreciated.

-------------
Tony

Replies:

Posted By: trusdamanr
Date Posted: July 08, 2002 at 12:43 PM

ok tony i might be able to help you first i know you probaly did it but check the resistor make sure its 180 ohms and its not open or shorted second double check the relay 86--- (-)from the input 85--- +12 volts fused 87--- ground and 30--- to the 180ohm resistor and to the purple and brown wire at the switch harness... and if you want change the output from constant to pulse .
posted_image

Print Page | Close Window