Print Page | Close Window

790XV remote not receiving ?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=17816
Printed Date: June 01, 2024 at 1:04 PM


Topic: 790XV remote not receiving ?

Posted By: jaxman
Subject: 790XV remote not receiving ?
Date Posted: August 19, 2003 at 11:43 AM

Hello all.

Just installed a Viper 790VX on a car and the remote will just act like a normal remote without the 2 ways comunication.
Does anybody know why the responder remote will not receive anything from the system ? Nothing is sent back from the system to the remote.



Replies:

Posted By: zargon
Date Posted: August 19, 2003 at 5:29 PM
I had that same problem and had to change out brains and remote.

-------------
zargon ruler of estranorth



Posted By: floaterr
Date Posted: August 20, 2003 at 2:20 PM
Just thorwing this out there but try reprogramming the remote..

This poses a question in my head. How does the remote know which alarm it is suppose to be listening to? If to 790's are in the same parking lot does the proper remote know to only listen to it's proper mate/car?



Posted By: jaxman
Date Posted: August 20, 2003 at 2:27 PM
Well found out that the cable was defective.

The remotes are pre programmed from the factory.



Posted By: zargon
Date Posted: August 20, 2003 at 4:11 PM
what cable was defective, we seem to have more problems with the 790 than with other viper systems.



Posted By: jaxman
Date Posted: August 20, 2003 at 4:39 PM
The antenna cable.I think one of the jacks at the end.Didn't saw the cable myself , one of my dealers had the problem.

First time when I had problems with 790XV.



Posted By: eurotek
Date Posted: August 23, 2003 at 8:32 PM

floattr how diiferent would that be when you use a standard remote, how does it know which car to operate? 

790 has a problem with the remotes... the circuit board cracks when pressing the buttons firmly.. DEI has solved the problem and is now shipping new remotes





Print Page | Close Window