Honda window wiring diagram

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=18869
Printed Date: May 21, 2024 at 12:02 PM

Topic: Honda window wiring diagram

Posted By: phamine
Subject: Honda window wiring diagram
Date Posted: September 14, 2003 at 9:11 AM

https://www.icelord.net/honda/repair/Wiring%20diagrams.pdf

It's on page 18.

I'm trying to plan out which wires to cut for dei 530t window module. I'm going to use only the driver side master window switches to control both the drivers window and the passenger window..

1. From the diagram(section A), for the passenger window switch on the master switch, blu/yel for up and blu/blk for down are connected to the passenger switch on the passenger side. The wires for the passenger window motor is connected to the passenger switch side.

My question is where should I cut the wires for the motor.? Should it be between the master switch and the passenger switch? Or should it be between the passenger switch and the motor?

2. Also from the diagram(section B), I'm confused about the driver side part of the master switch. Notice that there is only one wire for up and down for the switch(wht/blk). Should I just wire the up and down wires from the module to that single wire?

3. Lastly, The drivers window already has auto down. Should I wire the module to auto down part of the switch or the down part of the switch///?

thanks

Replies:

Posted By: Velocity Motors
Date Posted: September 14, 2003 at 10:10 AM

Grab the wires from the driver side switch. This is the master switch for both windows. Use the wires above and this will make the windows ( both ) go auto down with a module.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: phamine
Date Posted: September 20, 2003 at 10:44 PM

Velocity Motors wrote:

| LF WINDOW UP/DN|RED / yel, RED / blue |A |driver's door switch |
| RF WINDOW UP/DN|blue/grn, blue/yel |A |dr. door or kick panel |
Grab the wires from the driver side switch. This is the master switch for both windows. Use the wires above and this will make the windows ( both ) go auto down with a module.

Is that right? - the color codes are switched for up and down in the car database. Below is a diagram from the helms manual

Posted By: Velocity Motors
Date Posted: September 21, 2003 at 9:57 AM

This is for the 1993 Honda Prelude ?

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: phamine
Date Posted: September 22, 2003 at 7:08 AM

its for a 94. i just installed the window module. the wires are indeed backwards in the car database

Posted By: phamine
Date Posted: September 23, 2003 at 4:52 PM

I'm trying to wire another window module for the passenger side. However - it does not work. I would not be able to cut in half the blu/wht and the blue red wire since there isnt a motor side of for the wire. The motor side of the wire is blu/red and blu/wht.

I tried wiring it just using the blu/wht and the blu/red but it would not work. Any ideas?