mustang 2001 alarm
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=22370
Printed Date: May 19, 2024 at 5:33 AM
Topic: mustang 2001 alarm
Posted By: maxx3616
Subject: mustang 2001 alarm
Date Posted: December 04, 2003 at 10:10 PM
i m going to install a after market alarm.... do i have to take out the existing factory alarm..or do i just tap into it?
Replies:
Posted By: alarmpro
Date Posted: December 04, 2003 at 10:23 PM
Most likely its not an alarm just a keyless entry system with horn honk..(no shock sensor)You have to disable it or they will set each other off....go to the car diagram section of this site and see the disable wire color to disable it...
-------------
Posted By: profuse007
Date Posted: December 05, 2003 at 11:04 AM
check this post outits a good idea to leave the fact. unit intact, some car's resource is depended on the unit. ------------- Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
Posted By: maxx3616
Date Posted: December 11, 2003 at 2:20 AM
so i should leave the keyless entry alone?
i had another question
do i have to use any relays for my installation? or could i just tap into the wires i need to use?
Posted By: profuse007
Date Posted: December 11, 2003 at 2:36 AM
definitely leave teh keyless alone.
what type of alarm is this?
assume this is for security and keyless, no remote start
door locks-no
siren-no
trunk pop-definitely have to
disarm-depend on alarm unit
the rest of the wires are plug and chug
-------------
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
Posted By: maxx3616
Date Posted: December 11, 2003 at 9:49 AM
its the black widow... with lcd remote..
|